Rice Lake Okidata Microline ML 186 - Manual (Page 56)

56 • Operating Your Printer
10. Pull the paper lever (right side of printer) toward the front of the
printer—to the continuous forms position—and make sure the
paper is straight by adjusting it to align the left and right sides
behind the platen with the sides in front of the platen.
11. Push the paper lever back to the single sheet position to
reapply pressure on the platen.
12. Push the bail arm lever (left side of printer) back to close the
bail arm.
13. Replace the access cover:
a. Fit the cover tabs into the slots at the printer front.
b. Lower the cover carefully, making sure the paper fits through
the front slot in the access cover.
14. Lower the paper separator so that paper enters the printer
from under the separator and exits the printer going over the
separator (see “Correct Paper Path” diagram on page 53).
15. Turn the platen knob to move the paper to the point where you
want printing to start. (Many word processing packages
automatically allow for a top margin of 1 inch [25 mm]).
Important
Be sure that the paper covers the groove in the left end of the
platen so that it clears the paper out detector.
Note
To save this position as the permanent Top of Form,
press the TOF button.