Rice Lake Okidata Microline ML 186 - Manual (Page 68)

68 • Troubleshooting
Problem____________________________________________
My printer keeps indicating “Paper out” even though there is paper
installed.
Solution
The most likely cause is that the paper sensor groove at the left
end of the platen is not covered by the paper. Move the paper over
to cover the sensor groove.
Problem____________________________________________
When I am using continuous feed paper, the sprocket holes are
torn, causing alignment problems.
Solution
The most likely cause is that the paper lever (right side of printer)
is in the single sheet position. Make sure the lever is in the
continuous forms position (forward).