Rice Lake PR6202 Hygienic Weigh Module Kits - Manual (Page 6)

Mounting Kits PR 6002 Installation Manual
EN-4 Sartorius
2.3 Internal Lift-off Protection
All mounting kits are equipped with an internal lift-off protection; i.e. no bore holes other than the
mounting holes for the kit are required.
The Lift-off protection is realized by a bolt (2), nut (1) and a retainer (3). Bolt and nut are delivered in a
bag.
2 1
3
• Mount the lift-off protection after installation/alignment of the load cell.
• Do not turn the slots by more than 30° from the vertical.
2.4 Rubber Ring for Mounting
1…10 t 25…50 t
The rubber ring for mounting is used for vertical installation of the load cell.
• Place the rubber ring on the lower load disk.
• Position the load cell between the load disks.
• Lower the vessel and tighten the mounting screws.
• Pull out the four tabs on the rubber ring by approx. 15 mm so that the rubber ring is removed from
between load disk and load cell.
• Then tear or cut off the rubber ring to remove it completely.