2 attach pillar to scale base, Attach pillar to scale base – Rice Lake RL1200 Portable Beam Scale User Manual
Page 11
Advertising
Setting Up Your Scale
7
2.3.2 Attach Pillar to Scale Base
Use the following steps to attach the pillar to the scale base.
1. Screw the pillar rods into the scale base frame approximately three turns. Ensure ample threads are available
to place the beam weight rack and beam cap assembly on the pillar.
Figure 2-7. Screw Pillar Rods into Scale Platform
2. Place the pillar over the rods with the label facing the scale platform and the serial model label facing out-
wards as shown in Figure 2-8.
Figure 2-8. Place Pillar Over Pillar Rods
Advertising
This manual is related to the following products: