Welch Allyn Video Colposcope - User Manual - Manual (Page 18)

16 Components Welch Allyn Video Colposcope
Printer
NTSC PAL
REMOTE
1 2
~ AC IN
RS-2232C
INPUT
OUTPUT
S-VIDEO
S-VIDEO
VIDEO
VIDEO
Input Connectors. To connect the video equipment supplying the
source image.
Connector Connectable Equipment
S-VIDEO Equipment with a S-Video (Y/C) output
connector
VIDEO Equipment with a composite video signal
output connector
Output Connectors. To connect the video monitor. Refer to “Important
safeguards/notices for use in the medical environments.”
Connector Connectable Equipment
S-VIDEO Video Monitor with a S-Video (Y/C)
separated input connector
VIDEO Video Monitor with a composite video signal
input connector
~ AC IN. To connect the
printer to a wall outlet
with the supplied cord.
Equipotential Ground
Terminal Connector.
To connect to the
equipotential plug to bring
the various parts of a system
to the same potential.
RS-232C Connector. To connect the
Video Colposcope to control the printer.
NTSC/PAL (TV) Selector. Set this selector according to the TV system of the
input signal. If you change this setting, turn the printer power off and then back
on again.
Selector position When
NTSC NTSC system video equipment is connected.
PAL PAL system video equipment is connected.
Remote 1 Connector. To connect an RM-5500
Remote Control Unit (not supplied) to be used as
a wired remote control unit.
Remote 2 Connector. To connect an RM-91
Remove Control Unit (not supplied).
WARNING If peripheral devices (example: monitor, video printer, VCR ,other) do
not comply with IEC 60601-1-1, they must be kept out of the patient area (6 feet
minimum from patient).
Note For detailed instructions, please refer to the printer operation manual that has
been provided by the manufacturer. Printer shown is SONY UP-20; this is for
reference only.