Welch Allyn Video Colposcope - User Manual - Manual (Page 22)

20 Connections and Assembly Welch Allyn Video Colposcope
Vertical Stand Assembly
The Video Colposcope stand is shipped unassembled. Minimal assembly is required.
1. Remove the stand and base parts from their cartons.
2. Place base upside down on the floor and insert casters into holes on the bottom of
the base. (Do not place two locking casters next to each other.)
Locking caster
3. Place the base on the floor with casters down. Lock the two locking casters.
4. Place pole into the base, aligning the pin on the flange with the pin hole in the base.
Place bolt, spacer, and washer, oriented as shown, into the pole. Tighten securely
with the enclosed Allen wrench. (The assembly may need to be tilted.)
Allen Wrench
Hex Bolt
Spacer
Washer
Align pin with hole
Before using the Video Colposcope, refer to “Setting Up Video Colposcope” section
of this manual.
Swing Arm Stand Assembly
The Video Colposcope stand is shipped unassembled. Minimal assembly is required.
1. To assemble the stand, remove the stand and base parts from the cartons.
Note BASE WEIGHS 58 LBS. YOU MAY REQUIRE ASSISTANCE TO LIFT IT.