Welch Allyn Video Colposcope - User Manual - Manual (Page 27)

Directions for Use Operation 25
Vertical Height Adjustment Ring
(Vertical Colposcope Model Only)
The height of the vertical stand can be adjusted by rotating the black height adjustment
ring, located on the pole of the stand, counterclockwise. Once the ring has been
loosened, adjust the pole to the desired height and then tighten the ring again by rotating
it clockwise.
Swing Arm Height Adjustment
(Swing Arm Colposcope Model Only)
Adjust the height of the swing arm stand by loosening the height adjustment knob
located on the arm of the stand. The swing arm can then be moved to the desired
position. After moving the arm, tighten knob securely by rotating clockwise. The desired
drag can be obtained by adjusting this knob either clockwise or counterclockwise.
Positioning Video Colposcope
The video colposcope can be angled up and down and left and right. To change the up/
down tilt angle, loosen the knob located on the tilt axis. The video colposcope can then
be tilted as necessary. To change the horizontal angle, loosen the knob located on the
support shaft. The drag of either knob can be set by loosening or tightening as necessary.
Remote Video Functions
The handle of the video colposcope contains three buttons that control three video
functions. These functions, provided by a remote video printer or Welch Allyn software
program, are Freeze, Print, and Toggle. (See “Operation” on page 23. of this manual for
connecting the printer to the video colposcope.)
• Pressing the freeze (“F”) button stores a new image in memory. The frozen image
is displayed on the monitor or PC.
• Pressing the copy (“C”) button prints/saves the image displayed on the monitor.
If live video is displayed, the image visible when the button was pressed will be
printed/saved.
• Pressing the video (“V”) button changes the display from printer memory (frozen
image) to live video, or from live video to printer memory (frozen image), depending
on the current mode.