Garmin GPS 65 - Manual (Page 33)

IDD GARtllN
♦
IS
S.BHIl
1
«DI NAU P«SHRL«T
The scale settii^ is shown in the
bottom left comer.
* Highlight the scale setting field
with the arrow kej^ and change
the scale setting with CLR. You
may also change the scale settings
with the number keys (0-9).
1
IDD
GARHIHH
GARMIH
+
❖
»E
IINII
CDI
r
HAUP4SN PLOT
S
Finally, you may identify any
waypoint shown on the Plot Page.
- Select a scale setting that allows
you to see the destination waypoint
(GARMIN).
• With the arrow keys, h^hlight
the waypoint shown on the Plot
Map. Once highlighted, the
waypoint name is shown.
Experiment with your GPS 65.
You are on your way to masterii^ the GPS 65. If you let the simulator
run, you will eventually get a message, “Approaidui^ GARMIN”, just
prior to reachii^ the waypoint. Press PWR/STAT to view the message;
and again to return to the Plot Page.
You may also want to:
- Press NAV, WPT, GOTO, or any other key to become more
familiar with the available pages.
‘ Practice using the softkeys and cyclic fields to display new
information.
* Change the simulation speed (faster or slower).
* Read Chapter 6 on Unit Customization and set up the unit to your
preference.
- Stop the simulation. You can stop the simulation by turning the
unit off (press and hold PWR/STAT), or go to the “OP Mode” set up
and chгmge to the “Normal” or “Battery Saver” modes (see Section
6
.
1
).
3-19