Garmin GPS 65 User Manual
Page 63
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
** Sdnjject to accuracy degradation to 100m 2DRMS imder the
United States Department of Defense imposed Selective
Availability program. (Due to satellite geometry, altitude error is
typically two to three times the horizontal position error.)
ELECTRICAL WIRING
The GPS 65 power/data cable allows you to connect the unit to vehicle
power systems, other marine electronics, remote alarm/beeper, or an
external DGPS device thatoutputsRTCMSC-104, version 2.0 data. The
harness will plug into the connector located on the rear panel of the GPS
65.
To connect to vehicle power systems...
* Connect the RED harness lead (with fuse) to the positive (-i-) side
of a 5-40 volt DC power source.
* Connect the BLACKhamess lead to the negative(-)side of the 5-40
volt DC power source.
The GPS 65 will drive a remote alarm or relay that requires no more than
100 milliamps of current. (WARNING; Devices which draw current in
excess of 100 milHamperes may damage your tinit and will void your
warranty. Consult the inslxuctions included with the remote alarm or
relay for current drain information.)
To connect to a remote alarm system...
' Connect the RED/BLACK harness lead to the negative side of a
transistor alarm or relay switch.
C-3