Garmin GPS 65 - Manual (Page 55)

Ose Needs A4|ostnient - The GPS 65 has detected excessive drift in
its internal crystal oscUlator which may result in longer acquisition
time. The unit should be taken to an authorized GABMIN service center
as soon as possible.
Poor GPS Coverage - The GPS 65 cannot acqiiire sufficient satellites
necessary to provide navigation.
Pwr Down and Be*init - The GPS 65 is unable to compute a position
due to abnormal satellite conditions. Power down the unit and verify
that the position on the Position Page is within a few degrees of your
actual position.
Proximily Alarm • Your craft has penetrated the alarm circle of a
proximily waypoint
Proximity List Full - An attempt to upload more than nine proximity
waypoints has been made.
Proximity Overlap_______ - The circles defined by two proximity
waypoints overlay. When entering the area of the overlap, the GPS 75
will alert you ofthedosest proximity waypoint, butnotbo^ Youshould
be certain this condition is desirable.
Proximity Waypoint - An attempt has been made to delete a waypoint
for which a proximity alarm has been defined. You must remove the
waypoint from the proximity list before the waypoint can be deleted.
Received Invalid Wpt • A waypoint was received in an upload/
transfer operation that has an invtffid identifier or position.
Receiver Failed - The GPS 65 has detected a failure in the receiver
hardware. If the message persists, the GPS 65 is imusable and should
be taken to an authorized GARMIN service center.
ROM Failed - The GPS 65 has detected a failure in its permanent
memory. If this message occurs, the unit is unusable and should be
taken to an authorized GARMIN service center.
Route is Full • An attempt has been made to add more than 20
waypoints to a route. The GPS 65 wiU not allow more than 20 waypoints
per route.
Route Not Empty - An attempt has been made to copy a route to a non­
empty route. The GE*S 65 wül not allow you to copy a route to a non­
empty route.
A-2