Bissell ProHeat 2X 9200 SERIES - Manual (Page 12)

o
o
e
Turn Power and Heater switches OFF (O). Unplug
the machine and wrap the power cord.
After emptying the Water Tank, rinse it out at a fau­
cet with running hot tap water, taking care to ciean
underneath the Heavy Duty Biadder, and all around it
The top haif of .the Tank can be rinsed clean through
the nozzle area. Aiso, pop out the Red filter under­
neath the top half of fhe Tank and rinse that out.
Replace before puffing the.top and bottom halves of
the tank together. '
■ .
Before you place the cleaned Water Tank back onto
the machine, simply unscrew the Floor Nozzle using a
Phillips head screwdriver This can be rinsed out
at the faucet. Then replace back onto the machine by
starting from the bottom of the nozzle and hooking the
tabs into the holes on the bottom sides of the machine.
Secure into place with the screw.
The inside of the end caps by the brush rolls.can be
wiped out with a clean paper towel, or, if a more
thorough cleaning is desired, the end caps can .be
taken off using a Phillips head^ screwdriver and
rinsed clean. Replace after cle™g.
Any loose hair or debris can be pulled from the brush
rolls and thrown away. For the most thorough clean
before storage, follow directions on pages 17. & 18 for
removal and replacement of the brush rolls and belts.
After carpet is dry, vacuum again to remove hair
and fuzz, ::
' ' . . f
A few models are equipped with a Scotchgard
Protector post-treatment appiieator and
cartridge. Using this, along with one of
the BISSELL cieaning formuias containing
Scotchgard, can be used to heip retain the
carpet cleantiness achieved with the ProHeat
2X machine. For best results, the post
cleaning treatment should be applied while
the carpet is still damp. It is recommended
that the Scotchgard protector be applied
every t2 months to all clean carpeted areas,
and after every deep cleaning for high traffic
areas such as entryways and stairs.
Immediately after cleaning and rinsing your carpets,
empty the Water Tank and refill the Heavy Duty Bladder
with clean, hot tap water.
A w ARNING;
To reduce the risk of fire,
eiectric shock or injury,
unplug from fhe outlef
before servicing.