Bissell ProHeat 2X 9200 SERIES - Manual (Page 9)

o
o
o
o
o
O
Plan activities to give your carpet time to dry
Move furniture to another area if cleaning an
entire room (optional)
Vacuum area with a dry vacuum cleaner
thoroughly before deep cleaning
Pretreating (optional)
Pretreating Is recommended to Improve cleaning
effectiveness for heavily soiled carpet In high
traffic areas such as entryways and hallways. .
A. Spray the BISSELL Tough Stain
Pre-treat formula onto heavy traffic
areas, soiled areas, or stains.
B. Allow to penetrate for at least
3 minutes .
C. Clean as normal, using the BISSELL
Proheat 2X machine on the High
Traffic Setting, following the c
Instructions below. . .
Fill the Water Tank. Fill up the 2-in-1 Tank by
removing the Tank from the base of the machine
with the Tank Carry Handle. Carry like a bucket.
to the sink. Unlatch the top of the Tank from the
bottom by lifting the Tank Latch from the bottom t
at the back of the tank. Fill up the Heavy Duty; '
Bladder with clean hot tap water, t . . ■
*Do not boil or microwave water as it can
destroy the Bladder.
Leaving the filled bottom of the Water Tank on
a flat surface, only maneuver the top part of the
Tank. Replace the top of the Tank to the bottom
by carefully hooking the front of the nozzle into
the grooves on the bottom of the Tank. :
Note: Remember to secure the Tank
Latch in the back and test to make sure
it is secure before picking up the Tank.
ATTENTION:
Some Berber carpets have a
tendency to fuzz with wear.
Repeated strokes in the same
area with an ordinary vacuum
or deep cleaner may aggravate
this condition. Please see Stain
Removal instructions on page 15.