Bissell ProHeat 2X 9200 SERIES - Manual (Page 18)

o
Brushes can be removed for cleaning or
replacement as desired.
: Follow Belt Removal Instructions on page 17.
9
9
Remove Brush Rolls by pulling them off of the
metal rods. V
Place Cleaned or New Brush Rolls back onto the
rods. Make sure one washer Is on each end of
the rollers prior to sliding onto the rod. Be sure
to let the rod slide through the bushing to insure
proper fit, ■ : ' :
C | : ■
9
Re-attach the long belt on the bottom to the
9
9
9
cogs of the small roller brushes..
Place small belt over back roller and metal cog.
Place pivot arm In place and screw.in place
lusing the Silver screw. : ; ' '
Re-attach Clear End Cap by tightening with the
(2) Black screws. : C : .:V :. :;C
Return Front Nozzle to front ot unit, be latching
from underneath and then securing with a screw.
If you have any questions or are
having trouble installing or replacing your
belt(s) or brushes, please call BISSELL
Consumer Services at 1-800-237'7691.