B&C Technologies HI Series Commercial - Manual (Page 27)

Control Function Test
27
Installation
The machine should be cleaned after the
installation is complete. A function test
should then be executed on the unloaded
machine as follows:
1. Check the proper supply for such
characteristics as correct voltage,
phase, and cycles to be certain they
are correct for the machine.
2. Open manual shut-off water valves
to the machine.
3. Press Emergency Stop button.
4. Apply power to the machine.
5. Release the Emergency button.
6. Check the door interlock before
starting the machine.
a. Attempt to start the machine with the
door open. The machine should
not start with the door open.
b. Close the door without locking it and
attempt to start the machine. The
washer should not start with the
door unlocked.
c. Close and lock the door and start a
cycle. Attempt to open the door
while the cycle is in progress. The
door should not open.
If the door lock and interlock are not
functioning properly, call a service
technician.
7. For standard processing, select
program 30 by pressing key 3 and
key 0 on the keypad. Then press
enter and the Start key. Run the
complete program, checking
operation of water inlet valves,
drain , and extract functions.
Program 30 is a test program that
goes through most machine
functions.
8. Cylinder rotation must be counter-
clockwise in the extract step. If
rotation is not correct, disconnect
the power to the machine. A
qualified technician must reverse
any two leads between the AC
drive and the motor. See figure.
M
W V U
T3 T2 T1
INVERTER
DRIVE
TERMINALS