B&C Technologies HI Series Commercial - Manual (Page 32)

Operation
Wash Program Execution
while RESET will cancel the program.
During Drain
>
Drain valve blocked
> Drain hose blocked
> Faulty Drain Valve
Press RESET to end the program.
OVERLOADED!
DOOR OPEN!
DRAIN
Indicates a fault in the drive system. On
inverter driven equipment, indicates a drive
fault, on non inverter driven equipment,
indicates a motor overload condition. Press
RESET to clear the fault. If this fault recurs
during the next wash program, contact a
qualified service technician.
Indicates the door is not closed properly.
This fault disables the machine until cleared,
and aborts a program if active. Press
RESET to clear the fault.
Indicates a water level of greater than 2cm a
the onset of spin. The machine will resume
the spin when the level falls below the
threshold. Press RESET to abort the cycle.
Maintenance Request
After 450 wash programs have completed,
the machine will call for maintenance:
Maintenance Request
After 450 wash programs have completed,
the machine will call for maintenance:
32
The message appears at the start of a
program, and is repeated at the beginning
of each wash program until reset (see
function 217 in the EL6 Programming and
Operation Manual for full details). Before
resetting the alarm, PERFORM ROUTINE
MAINTENANCE AS OUTLINED
ELSEWHERE IN THIS MANUAL.
For further information regarding access
functions and programming, see the EL-6
Computer Programming and Operating
Instructions manual, included with the
machine.
The message appears at the start of a
program, and is repeated at the beginning
of each wash program until reset (see
function 217 in the EL6 Programming and
Operation Manual for full details). Before
resetting the alarm, PERFORM ROUTINE
MAINTENANCE AS OUTLINED
ELSEWHERE IN THIS MANUAL.
MAINTENANCE MAINTENANCE