Canon GL2 - Manual (Page 109)

109
E
Editing
1. Open the menu and select VCR SET UP.
2. Select AUDIO DUB.
3. Select AUDIO IN or MIC. IN and close the menu.
4. Locate the point where you wish to start audio dubbing, then press the
e/a
button or the PAUSE button.
• You can use the playback buttons on the camcorder or the special playback functions on the
wireless controller in the same way as in playback mode.
• The camcorder becomes set to playback pause mode.
5. Press AUDIO DUB.
• AUDIO DUB. and 2a appear on the display.
AUDIO DUB.••• AUDIO IN VCR SET UP
( 20)
REW PLAY FF
REMOTE SET
SEARCH
SELECT
ZERO SET
MEMORY
AUDIO
DUB.
STOP
AV
INSERT
PAUSE SLOW
+ / – /
×2
/
AUDIO
REC LEVEL
A M
Do not connect/disconnect any cables to/from the camcorder when dubbing audio or preparing to
dub audio.
Turn the camcorder’s POWER switch to PLAY (VCR) and move the camcorder’s TAPE/CARD switch to
TAPE. Load a recorded cassette.
• Make sure the REC/SAVE tab on the cassette has been slid to REC (closed position).
Preparations
+ PLAY
(VCR)
TAPE
Dubbing