Canon GL2 - Manual (Page 93)

93
E
Pla
ybac
k
This allows you to move quickly through still images (photo search), between different days or areas
of recording (date search), or index signals (
59) recorded anywhere on a tape (index search).
1. Press the SEARCH SELECT button to select between photo/date/index search.
• PHOTO SEARCH, DATE SEARCH or INDEX SEARCH appears for 4 seconds.
2. Press the - and + buttons to move backwards or forwards through the still
images, between different days of recording or recorded index signals.
• Press once to move to the start of the previous/next still image, day or index on the tape.
• You can press more than once to move to the corresponding still image, day or index (up to a
maximum of 10 times), e.g. press the + button 5 times to move forward 5 still images, days
or index signals.
• PHOTO SEARCH/DATE SEARCH/INDEX SEARCH appears in the middle of the display alongside
the - or + mark and number to search through. You can change the direction easily by
pressing the button for the opposite direction.
Notes:
• Press
3 (stop) to stop searching.
• If you begin a search very close to the start of a recorded still image during photo search, the
camcorder may skip straight past it.
• When you have set the time zone, date search also looks for the change in date based on the
adjusted time.
• A date/time zone cannot be identified if the total recording time on that day/time zone was less
than 1 minute.
• Date/index search playback may start slightly before or after the beginning of the located section.
• If the data code is not displayed correctly you will not be able to operate the date search correctly.
REW PLAY FF
REMOTE SET
SEARCH
SELECT
ZERO SET
MEMORY
AUDIO
DUB.
STOP
AV
INSERT
PAUSE SLOW ×2
+ / – /
+ PLAY
(VCR)
TAPE
Searching the Tape (Photo Search/Date Search/Index Search)