OFNA Racing Worlds II - Manual (Page 13)

Assembly of the right and left hand side
are the same.
0 0
1 1
R R
#36640
Upper arm Shaft
#90021
3mm E-Ring
#90021
3mm E-Ring
#90021
3mm E-Ring
3mm
Nylon Nut
#36055
2.5 x 17mm
Pin
#36054
17mm Wheel Hub
( Alum. ) 8mm Axle
3 x 3mm
Set Screw
#30340
6mm
Stabilizer
Ball End
Assembly of the right and left hand side
are the same.
ASSEMBLY OF THE FRONT LOWER ARMS
ONTO THE GEAR BOX, K STLYLE
4 x 10mm
Tapping Screw
0
1
R R
* Insert drive shaft
before assembly.
#36630
Lower Arms Shaft
4 x 10mm
Tapping Screw
#36720
Lower Arms
Stiffener
(Alum.)
3mm
E-Ring
A-34B
3 x 25mm
Cap Screw
#30102
Front Body Post
* Cut the sharded area
as shown.
3x8mm
Tapping Screw
3 x 8mm
Tapping Screw
R R
R R
ASSEMBLY OF THE FRONT KNUCKLE ARM AND
FRONT UNIVERSAL JOINT, K STYLE
4 X 10mm
Set Screw
* A 4 x 10mm set screw is used
to adjust the ride height.
#36120
Knuckle arm
Bushing & screw
#36120
Knuckle arm
Bushing & screw
#36052
CVA, Constant Velocity Axle
8mm
#36053
Bearing
8 x 16 x 5
#36053
Bearing
8 x 16 x 5
#36051
Front, Knuckle Arms
(R/L) 8mm
#36060
Front C Hub
(Right)
#36870
4 x 10mm
Cap Screw
#36010
Front Lower Arm
#36870
4 x 10mm
Cap Screw
2.5mm
E-Ring
2.5mm
E-Ring
#36170
3mm
Rear Arm Shaft
ASSEMBLY OF THE FRONT SUSPENSION ARMS, K STYLE
Assembly of the right and left hand side
are the same.
Assembly of the right and left hand side
are the same.
3 x 20mm
Flat Head
Tapping Screw
#30160
Front Lower
Arm Holder
4 x 15mm
Tapping Screw
0
1
ASSEMBLY OF THE FRONT SUSPENSION ARMS, K STYLE
* Builds two front upper arms for left
and right-side. .
#36020
Front, Upper Arms
#36690
Plastic, Arm Ball End
#36860
5x40mm
Turnbuckle
#36850
7mm Ball
0 10 20 30 40 50
mm
* Anticlockwise mark.
13mm
0.5MM
* If too tight, cut or sand to fit
the shaded area as shown.
* Insert knuckle arm bushing
before assembly knuckle.
* Approx 3mm.