OFNA Racing Worlds II - Manual (Page 15)

Assembly of the right and left hand side
are the same.
Assembly of the right and left hand side
are the same.
#36870
4 X 10mm
Set Screw
* A 4 x 10mm set screw is used
to adjust the ride height.
#36720
Lower Arm
Stiffener
(Alum.)
3mm
E-Ring
3mm
E-Ring
3mm
E-Ring
#36630
Arm Shaft
#36030
Rear Lower
Arms, K Style
#36902
Rear Lower
Arms, M Style
* Don't over tighten tapping screw,
will cause bending.
#36810
Rear Shock
Tower
#30340
Anti-roll Bar Kitr
* Insert stabilizer before
assembly of the shock stay.
ASSEMBLY OF THE REAR SHOCK TOWER
ASSEMBLY OF THE REAR ARMS, K & M STYLE
4x16mm
Flat Head
Tapping Screw
3 x 20mm
Flat Head
Screw
#36090
Rear Arm
Holder & Toe-in
#36090
Rear Wheel Toe-in
Adjuster
1
Degree 1.5
Degree
* Set triangle marks in
the direction shown
in Fig.1.
* Approx 3mm.
Fig.1
Toe-in Settings
ASSEMBLY OF THE
STABILIZER ROD
0 0
1 1
R R
#30402
3 X 30mm
Tie Rod
#30401
6mm Plastic
Stabilizer
Ball End
#30401
6mm Plastic
Stabilizer
Ball End
3 x 15mm
Screw
ASSEMBLY OF THE SHOCKS ONTO
THE SHOCK TOWER
0 0
1 1
R R
#30411
6mm
Ball Joint
#30411
6mm
Ball Joint
3mm
Nylon Locknut
* Insert shocks ball end
into arms.
Assembly of the right and left hand side
are the same.
Assembly of the right and left hand side
are the same.
3 x 15mm
Screw
3 x 25mm
Cap Screw
3 x 15mm Screw
3 x 25mm
Cap Screw
#36610
Spacer, Shock Support
* Insert into arms.
0 10 20 30 40 50
mm
14mm
Sc
re
w
Ce
m
en
t
3 x 8mm
Washer
3 x 15mm Screw
M3 Nylon Locknut
3 X 8mm Washer
* Cut the shaded area as shown