OFNA Racing Worlds II - Manual (Page 26)

ASSEMBLY OF THE FUEL TUBE
* Connect to
fuel nipple.
* Connect to
carbulater.
* Connect to fuel tank
pessure nipple.
3 x 10mm
Tapping Screw
3 x 10mm
Tapping Screw
#10273
Servo Post Mounts
#10273
Servo Post Mounts
Throttle Servo
Steering Servo
3 x 10mm
Screw
3 x 10mm
Screw
#30520
Radio Tray
Post, Alum.
#36770
Radio Tray
#10178 - Yellow
#10179 - Lt. Blue
Silicone Fuel Tubing, 3ft.
* Take the radio tray post and
servo post from receiver box
plastic parts.
In U.S. Kits, the post are
CNC Alum. Instead of Plastic
Use Machine Screw instead of Tapping as shown.
ASSEMBLY OF THE RADIO TRAY AND SERVO
* Connect to
press nipple.
3 x 10mm
Tapping Screw
ASSEMBLY OF THE BRAKE SYSTEM
3X3mm
Set Screw
A-80B
2mm
Adjust Nut
Servo Mount
2x25mm
Screw
#30800
Brake System Plastic Parts Set
Adjust
Mount
3mm
Nut
Slider
3x12mm
Screw
2x8mm
Screw
2mm Nut
2mm
Tie-Rod End
2mm
Tie-Rod End
2x6mm
Washer
2x6mm
Washer
2x4mm
Screw
2x4mm
Screw
Screw
Cement
#10273
Servo Post Mounts
INSTALLATION OF THE FUEL TANK
AND ENGINE ONTO CHASSIS
Note Book Paper
*Use note book paper to set
gear backlash between spur gear
and clutch bell gear.
If the space is not correct the spur gear
will be damaged.
3 X 20mm
Cap Screw
Spur Gear
Clutch Bell
* Loose or tighten 3x20mm cap screw
and 5x10mm hex screw to align
spur gear and clutch bell same
as shown.
5x12mm
Washer
( 4 pcs )
5x10mm
Hex Screw
( 4 pcs )
3 x 10mm
Tapping Screw
3 x 10mm
Tapping Screw
Plastic Post
Plastic Post
3 x 15mm
Screw
3 x 15mm
Screw
Pressure Nipple
Fuel Nipple
*Tighten the strap
and cut off the excess.
#10180
Silicone Tube
#10069
Manifold Adapter
( Red Silicone )
#10120
Manifold
Spring
5x5mm
Set Screw 4x1omm
Flat Head
Screw
#30491
Muffler Mount
Wire
You must bend wire as
shown,
4mm
Nylon
Locknut
ASSEMBLY OF THE MANIFOLD AND
MUFFLER
Nylon Strap
( Large )
#10060
Manifold
#10111
Motor Mount Screw set
#10079
Alum. CNC
Pressure Nipple
#30490
Muffler
* Drill a hole (Size 3.5mm)
in the place and align as shown.
Use a two part high temp. epoxy glue to
fully seal the nipple base.
#30280
Fuel Tank
* Take the plastic post
from the receiver box
plastic parts.
3 x 10mm Screw
3 x 10 mm Flat Head
Screw