OFNA Racing Worlds II - Manual (Page 33)

PAINTING TIPS
STEP 1 STEP 2 STEP 3
STEP 4 STEP 5 STEP 6
STER 7
STER 10
STEP 8 STEP 9
Wash the inside of the body with detergent to
remove any oil and dirt. Dry with lint free towel
or a hair dryer. (Keep your hand clean.) Tools required are: Curved scissor , hobby knife
and a quality masking tape. These can be pur-
chase at your local hobby supplier. Use the curved scissors to trim the body to
the guide lines provided on you body shell.
Use masking tape on the inside of the body to
mask out your design and windows prior to
painting. Press down the edges! Paint the inside of the body!
Use a spray color suitable for polycarbonate.
(Paint the darkest color first.) Allow the paint to dry for at least an hour!
Remove the masking tape and protection film
from the outside of the body.
Apply the decals to the outside of the body.
We suggest use a hobby knife to cut them out. Use a hobby knife to cut holes for fuel tank ,
engine and antenna tube .
Make two 7mm holes for the body posts; one at
the front and one at the rear.
the Drill two 7mm holes in nylon wing.
Using the measurements provided in the
instruction. Use the clip provided to secure the
wing to the wing mount posts.
Mounting the body to the buggy using the
body using body clips provided.
For BUGGY
Factory Body Shown
# 36830
U.S. Body, in kit
# 36831
ASSEMBLY OF THE TIRES, FOAM INSERTS AND WHEELS
#86044 - Red
#86045 - White
#86046 - Lime
#86047 - Yellow
17mm 5-Star Wheels
#86091
Mini XX- Pin Tire
#15071
17mm Wheel Nuts
#15071
17mm Wheel Nuts
* Apply instant glue into
the groove of the wheel.
WE RECOMMEND CA GLUE
FOR RUBBER TIRES.
Foam Donuts (blue) are supplied
with your kit. Place them into the tire before
gluing. Do not use too much glue
or get glue into tire and onto foam.
IN ST
AN
T GL
UE INST
AN
T
G
LU E
R R
Front Knuckle Arm
Assembly
Rear Hub Assembly
STARTING OF THE ENGINE
How to start the engine:
1. Turn on transmitter and then receiver.
2. Fill fuel tank with fuel bottle.
3. Connect 1.2V glow plug starter.
4. Start engine with 12V starter or starter box
( Note the direction of the starter.)
5. After the engine be started, remove the
1.2V glow plug starter.
1.2V
Glow Plug
Starter
* Follow the engine manufacturer instruction manuals
regarding engine set-up, carburetor and maintenance.
Connect with 12V battery
* Note the direction of the
starter.
Rubber wheel turns engine
flywheel.
12V Starter
* To start the engine, use hand held starter
motor or starter box.
#10250
Starter Box