Assembly of the front steering rod, Assembly of the radio tray onto chassis, Assembly of the throttle linkage system – OFNA Racing Worlds II User Manual
Page 31
0 10 20 30 40 50
mm
#30402
3 X 30mm
Tie Rod
#30410
6mm
Ball & Socket End
ASSEMBLY OF THE FRONT STEERING ROD
* To the steering
servo saver.
3x12mm
Screw
3x12mm
Screw
* Align the steering servo as shown.
20mm
3 x 12mm Screw
#30410
6mm
Ball & Socket End
#30410
6mm
Ball & Socket End
#30410
6mm
Ball & Socket End
ASSEMBLY OF THE RADIO TRAY ONTO CHASSIS
3X10MM
Flat Head
Tapping Screw
3X10MM
Flat Head
Tapping Screw
3X10MM
Flat Head
Tapping Screw
3X10MM
Flat Head
Tapping Screw
3 x 10mm Flat Head
Tapping Screw
#30560
Antenna Tube
3x10mm
Tapping
Screw
3 x 10mm
Tapping Screw
ASSEMBLY OF THE THROTTLE LINKAGE SYSTEM
3X3mm
Set Screw
3X3mm
Set Screw
3X3mm
Set Screw
Plastic Collar
* Take the plastic collar
from brake system plastic
parts.
Throttle
Spring
#10300
Alum.Stopper
#10300
Alum.Stopper
* Snap On.
#30530
Plastic Throttle
Ball Joint
2mm Rod
Fuel
Tube
( 6mm )
Idle Position
Brake
Full Throttle
* Align throttle servo same
as shown.
Both throttle and steering servo arms are not
included in kit and are found with the radio
installation hardware. But, if you wish to
purchase stronger servo arms, OFNA has
them in four colors. See hardware and
specialty items on back pages of this