OFNA Racing Worlds II - Manual (Page 17)

3mm
Nylon Locknut
3 x 25mm
Cap Screw
* Insert into rear hub.
3 x 25mm
Cap Screw
G-01
Shock Support
ASSEMBLY OF THE STABILIZER ROD
ASSEMBLY OF THE REAR UPPER ARM ROD
Assembly of the right and left hand side
are the same.
3 x 15mm Screw
3 x 25mm
Cap Screw
3 X 25mm Cap Screw
#30402
3 X 30mm
Tie Rod
#30411
6mm
Ball Joint
#30401
6mm
Stabilizer
Ball End
#30401
6mm
Stabilizer
Ball End
3 x 15mm
Screw
3 x 3mm
Set Screw
#30340
6mm
Stabilizer
Ball End
Assembly of the right and left hand side
are the same. 0 10 20 30 40 50
mm
15mm
3 x 15mm
Screw
M3
Nylon Locknut
M3 Nylon Locknut
Assembly of the right and left hand side
are the same.
Assembly of the right and left hand side
are the same.
ASSEMBLY OF THE REAR HUB, K & M STYLE
#36053
8 x 16 x 5
Ball Bearings
#36053
8 x 16 x 5
Ball Bearings
#36082
Rear Wheel
8mm Axle Shaft
#36055
2.5 x 17mm
Pin
#36054
Wheel Hub
( Alum. )
#36054
Rear Hub
K or M Style
* Builds two upper Rods for left
and right-side.
#36690
Arm Ball End
#36690
Arm Ball End
#36880
5x60mm
Turnbuckle
#36850
7mm Ball
0 10 20 30 40 50
mm
* Anticlockwise mark.
40mm
ASSEMBLY OF THE REAR HUBS ONTO
THE REAR ARMS, K & M STYLE
2.5mm
E-Ring
2.5mm
E-Ring
#36170
3mm
Rear Arm Shaft
5x5mm
Set Screw
* Insert rear drive shaft
befor assembly.
#36110
Rear Drive
Shaft
* Do not overtightened
set screw.