Storix Software SBAdmin AIX System Recovery Guide - Manual (Page 24)

Storix System Backup Administrator 24 Version 8.2 AIX System Recovery Guide
c33 User selected an ASCII display as a console device
c40 AIX installation programs are being restored from the boot tape
c43 Error restoring the AIX install programs during a tape boot
Either the tape media is defective, the tape drive is defective, or the boot tape is incomplete. Create
another boot tape and try booting from tape again.
c45 Failed to configure a system console or find a console device
The cfgcon command failed because of missing device support for either the graphic adapter or
standard I/O slot for ascii monitors. You must install the appropriate device support on the system from
which the backup tape was made, then recreate the system backup.
c46 Normal installation is in process
This LED will appear throughout most of the installation to indicate normal processing.
c47 Unable to create a PVID on a disk
This normally indicates a hard disk failure. If installing on the disk for the first time, try checking and/or
reformatting the disk in diagnostics and retry the install.
c48 User is being prompted for input at the console
This is the normal LED to be displayed during a prompted installation when the installation menus
appear. If this is a no-prompt installation, this LED will appear to indicate that a configuration or
installation error has occurred and the user is now being prompted for input at the system console.
Check the console for errors and proceed accordingly.
c49 Could not format a JFS log logical volume
The logform command failed to format the JFS log logical volume (typically hd8) during a recovery
installation. You will be placed in a maintenance shell. Format the log logical volume manually and
continue the installation.
c50 Creating the rootvg volume group on disk
c52 Initializing base operating system after restoration of base operating system files
c54 Restoring the base operating system files from the backup media
c55 Could not remove the root (hd4) or /usr (hd2) logical volumes
The rmlv command failed to remove a logical volume during a recovery installation process. You will be
placed at a maintenance shell. Manually remove the logical volumes, then continue the installation.
c57 Error restoring filesystem or logical volume data
If this error occurs, there was a problem restoring either the filesystem data or raw logical volume data
from the backup, and typically indicates an error reading the backup media. If this occurs in the / or /usr
filesystem, the problem must be corrected and the data must be restored from the media for the
installation to continue. If this occurs for any other filesystem or logical volume, you may continue the
installation without restoring the data. In this case, the installation will complete successfully, but you
must restore the missing data after the system reboots in normal mode.
c59 An error occurred initializing the base operating system
If this error occurs, the system was unable to switch to the restored operating system after restoration
of the base operating system files. This will typically only occur if there was an error reading the