Storix Software SBAdmin AIX System Recovery Guide - Manual (Page 26)

Storix System Backup Administrator 26 Version 8.2 AIX System Recovery Guide
3. An /etc/tftpaccess.ctl file exists on the boot server but does not provide access to the
/storix/netboot directory (where ‘/storix’ is the SBAdmin data directory).
4. On a PCI-based system, you cannot use the leading zeros for any of the IP address in the
SMS Menu. Even though the first tftp command works the second one will fail.
Recreate the network boot image on the server and re-enable the network boot client , making sure all
values are correct.
613 Could not configure route to boot server
The route command failed to establish a route to the boot server. Check that the gateway address is
correct, or remove the gateway address from the network boot configuration if no gateway is required
for the client to reach the boot server.
614 Could not contact the install server
The client could not contact the install server because there was a network communication error.
SBAdmin commands are used to communicate between client and server at this time. You must check
that the server is running the same level of SBAdmin that the client was booted under, and that the
server has been properly configured for network communications. You must also be sure that the
server has enabled the client permission to read from a remote backup on the server.
615 Could not read the second part of the boot image from the boot server.
The boot images on the server are incomplete. Rebuild the boot images on the server and try to boot
the client again.