CANOGA PERKINS 1502 Domain Management Module - Manual (Page 32)

EdgeAccess Universal Chassis System
Model 1502 Domain Management Module 3-22
4. At the Virtual Group Management screen, make any of these selections:
• To add a module to a Virtual Group, type
1 , then at the prompt, enter the Chassis and
Slot for the module, and press <Enter>.
• To delete a module from the selected Virtual Group, type
2 , then at the prompt, enter the
Chassis and Slot for the module, and press <Enter>.
Note The delete option in the Virtual Group Management menu deletes an entire Virtual
Group. To delete a single module in a Virtual Group, first select the Virtual Group, then
at the Virtual Group Management screen, select and delete that module.
• To save the Virtual Group information, type
3 and press <Enter>. Always save changes
to Virtual Groups before you return to the Virtual Group Management menu.
• To reset all modules in the selected Virtual Group, type
r and press <Enter>.
• To swap firmware banks in all modules in the selected Virtual Group, type
s and press
<Enter>.
5. To return to the Main Menu, press <Esc>.
Manage a Chassis
You can manage the modules within a chassis. You can view information, such as type, status,
software versions, remote partners, or power consumption, about all modules in a single chassis.
Use the Chassis Management screen to view information about and status for each Chassis in the
Domain and to access specific modules within that chassis. If you want to add or change modules
within a chassis in the domain, check this screen to be sure that the power supply(s) can provide
the additional capacity. To access the Chassis Management menu, follow these steps:
1. At the Main Menu, type 3 , "Manage or access a specific Chassis" and press <Enter>.
2. The chassis selection appears at the right of item 3; press <Space> to cycle through the
chassis that are online, then press <Enter> to select a chassis. The Chassis Management
screen appears; it shows the module and status for each slot in the chassis. See Figure 7.
• To view a second screen if all slots do not fit on the first screen, press <Tab>.
• To view the Local and Remote Bootcode and Firmware, both Active and Inactive,
version numbers for all modules, type t . See Figure 8.
• To view the power consumption for each module and the total power still available for
additional modules in the chassis, type t again. See Figure 9.
• To choose a specific module from the list on the Chassis Management screen, press
<Space> to cycle through the slots to that module, then press <Enter>; the user interface
for that module appears. For details on the module, see the User Manual for that module.
3. To return to the Main Menu, press <Esc>.