CANOGA PERKINS 1502 Domain Management Module - Manual (Page 9)

EdgeAccess Universal Chassis System
Model 1502 Domain Management Module 2-1
Chapter 2
Hardware Installation and Functions
This section describes how to install the DMM in the UCS Model 1002.
Setup and Installation
The DMM is installed in the UCS 1002 Chassis in slot 1 at the factory. Occasionally, you may need
to install a DMM in a UCS 1002, if ordered separately. The DMM can be installed anywhere from
slot 1 to slot 14. To install the DMM, see Figure 3 and follow these steps:
1. If multiple chassis will be linked, set up the chassis ID numbers. For details on setting the
Chassis ID switch on each backplane, see the Universal Chassis System UCS 1002 User Manual.
2. Set SW3 to FD for full duplex or HD for half duplex Ethernet.
3. Set the MDX/MDI switch to MDI for a straight through cable or to MDX for a crossover cable.
SW3
MDX/MDI Switch
Figure 3. SW3 for Full Duplex (FD) or Half Duplex (HD) Ethernet and MDX/MDI Switch
4. Insert the DMM in any slot except slot 0, pushing it firmly into the connector. Do not force it.
5. Hand-tighten the captive screws to secure the DMM in the chassis.
Note: The DMM is hot-swappable and can be inserted or removed at any time without affecting
data transfer in other modules.
6. If the chassis power is off, switch on the DC power supply(s) for the chassis or plug in the AC
power supply(s). The DMM receives power through the backplane. During the power-on self-
test, all LEDs light amber.
7. At the end of self-test, check for these LED conditions:
• STA lights green
• ACT, LNK, and Rx may be green or off, depending on current management activity