CANOGA PERKINS 2370 High-Speed Universal Fiber Optic Modem - Manual (Page 29)

EdgeAccess Universal Chassis System
Model 2370 Model User Manual 4-5
Table 11. System Configuration Option Definitions
Menu Item Description
1) Hardware Configuration Reports information about the local and remote modems
2) Functional Configuration Reports modem status; set ELIM values and loopback options
3) Trap Configuration Enable or disable traps
4) Alarm Output Configuration Enable or disable the alarm outputs; set alarm levels
5) SNMP Configuration Reports Ethernet information; set up SNMP parameters
4.6 Hardware Configuration
The Hardware Configuration screen reports information about the local and remote primary and
secondary modems. See Figure 11. To view the Hardware Configuration report, follow these steps:
1. At the System Configuration menu type
1
, "Hardware Configuration," and press <Enter>. The
Hardware Configuration screen appears.
2. To return to the System Configuration menu, press <Esc>.
--------------------------HARDWARE CONFIGURATION------------------------
Local Remote
Pri. Sec. Pri. Sec.
Chassis/Slot 5/8 Standalone Standalone Standalone
Chassis Type 5U UCS 1000 1040 1040 1040
Power Supply Pri AC 120/240 AC 120/240 AC 120/240 AC 120/240
Power Supply Sec N/A N/A N/A N/A
Fan Installed N/A N/A N/A N/A
Modem Model 2370-1313 2370-1313 2370-1313 2370-1313
Modem Type 1310 MM SC 10dB 1310 MM SC 10dB 1310 MM SC 10dB 1310 MM SC 10dB
Modem Revision A1 A1 A1 A1
Modem Serial No. 20030694501 20021019450 20021945010 20021014945
ELIM Model L130 L130 L130 L130
ELIM Type Configurable Configurable Configurable Configurable
ELIM Revision A1 A1 A1 A1
ELIM Serial No. 20030592525 20021925255 20021039252 20029252503
Figure 11. Hardware Configuration Screen
4.7 Functional Configuration
The Functional Configuration report and menu provides information about the local and remote
interfaces, LOS detection, and redundancy, with options to set all values. See Figure 12 and
Table 12. The Oscillator (MHz) parameter shows the frequency of the optical oscillator, or shows
N/A if no oscillator is installed. Some parameters are valid for only certain interfaces and settings
and show N/A in all conditions that do not apply. For information about the various electrical
interfaces and the operating modes, see Chapter 3.