CANOGA PERKINS 2370 High-Speed Universal Fiber Optic Modem - Manual (Page 36)

EdgeAccess Universal Chassis System
Model 2370 Model User Manual 4-12
Item Description
10) BOOTP Enabled Enable this if the module needs to obtain its IP address from a
BOOTP server; when the unit has an IP address, disable BOOTP
11) Serial Port Config Set the type of serial port connection: VT100, SLIP, or PPP
12) Telnet Timeout Set the time with no activity until a Telnet connection automatically
logs out
13) Host Table Go to the Host Table screen
4.11 Host Table
The SNMP agent allows access to up to 24 Host IP addresses listed in the Host Table. Set up the
Host information for the 2370 on the Host Table screen. See Figure 16. To access the Host Table,
follow these steps:
1. From the SNMP Configuration menu, type
13
, Host Table, and press <Enter>. The Host Table
screen appears.
2. To add a host, type
1
and press <Enter>, then follow the prompts, to enter values for these
parameters:
a. IP Address for the Host
b. Access level for the host; can be
1
, read;
2
, read/write;
3
, read/trap; or
4
, read/write/trap
c. Trap community string (up to 10 characters)
3. To delete a host, type
2
and press <Enter>, then at the prompt, enter IP Address for the Host.
4. Type
Y
to confirm your changes and save them. The host table appears again with your changes.
5. To return to the SNMP Configuration menu, press <Esc>.
-------------------------------HOST TABLE------------------------------
Managing
Access Trap Trap Managing Access Trap Trap
Host Level Community Port Host Level Community Port
------------------------------------ ------------------------------------
172.16.142.20 4 public 162
Add or Delete a host entry (1=Add, 2=Delete from table):
Figure 16. Host Table Screen