Daiwa SEABORG-300FB - Manual (Page 10)

8
- This display allows you to change setting of each function.
- Functions that are operable, once set will light up and blink.
Display Function Function Display
Names of the buttons and the display
Pressing the JIG/PICKUP BUTTON makes
the function work. Pressing the button
again stops it.
Chumming timer starts working.
Auto Line feeding is employed. Default
setting is off.
Pressing the RESET BUTTON makes this
indicator appear. (If the RESET BUTTON
is not pressed, Auto Stop will work at 5.0m
from the broadside.)
JIG/PICKUP BUTTON
Mode display
Depth counter
3
5
6
8
Selection between pickup and jigging can be done in the mode setting display.(One of them should necessarily be chosen.)
Pickup
-You can wind only while pressing this button. This function is useful to wind up line slack and attract fish.
Jigging
- Jigging can be ON/OFF.
- Pressing this button starts jigging. (Display shows )
- Pressing the button again stops jigging.
MODE BUTTON 4
- It shows the depth from the surface.
Inverse counter
Chumming timer (Power indicator, time to wind up, timer display)
7
- The chumming timer appears when motor rotation is stopped.The timer display cannot be set to OFF.
-This counter shows the depth from the bottom (or a certain depth).
- Once this counter is turned on, its display cannot be turned off.
-Winding speed can be changed within the range of 0-Hi with the mode setting display. (Default setting is speed 15)
-If the winding speed is set to 0, pressing the button will not start the winding operation. Also, will not be
displayed on the counter screen.
- Simultaneously press the INVERSE COUNTER BUTTON and the JIG/PICK UP BUTTON for two seconds to
select a "setting screen" of various useful functions.
- Once setting selection has been made, the setting will be applied on the next fishing trip.
- Use the Power Lever to adjust numeric values.
- Pressing the MODE BUTTON sets the numeric values you have adjusted.
- Depress and hold the MODE BUTTON to return to the depth display.
- Mode change cannot be done while line is being fed.
While the JIG/PICKUP BUTTON is being
pressed, the line can be electrically
wound up.
If the supply voltage drops, the indicator
will blink. (Pressing the MODE BUTTON
does not change the indication.)