Daiwa SEABORG-300FB - Manual (Page 15)

13
Line data input
(With backing line)
This method requires use of Daiwa braided line that is color coded to show length and has a total
length greater than 100 m.
Backing line
1. Run the backing line through the levelwind guide and tie it onto
the spool. The levelwind threader makes this process easier.
Make sure to tie the line onto the pin found on the spool to
avoid the line slipping.
6
2.
Move the power lever to the OFF position.
3. Connect the clip to the power source (12V DC).
6. Tie the backing line securely to the main line.
5. Wind the line to its end with the power lever at maximum.
4. Attach the cord connector to the reel.
See in page 2 for the connection method.
P2 Inputting Line Backing
or
7
1 Levelwind Guide
Pin
Power lever
2
Main line
Backing line
Tie
P0 will be blinking.
7. While “ 0.0 ” is shown in the display, press INVERSE COUNTER
BUTTON and JIG/PICKUP BUTTON simultaneously and hold
for 6 seconds, until the display shows P0 on left area of the
display.
The display will change to the pickup mode 2 seconds after the
buttons are pressed, but keep pressing the buttons, and the
display will change to the line setting mode.
(Inputting the line
length display)
MODE
(JIG/PICKUP)
BUTTON
MODE
(JIG/PICKUP)
BUTTON
Then, press the MODE (JIG/PICKUP) BUTTON so that P1
starts blinking.