Functional setting operation, Auto stop function) – Daiwa SEABORG-300FB User Manual
Page 22
20
1
Auto stop setting
The Auto stop depth may be set to meet your own specific needs.
1.
Connect the reel to the battery, and press the
RESET BUTTON
with your terminal rig at the surface.
The display shows
0.0
.
- Auto stop adjusts to operate at depths from 1 m to 5 m (in 10 cm increments).
- It prevents accidentally winding swivels, terminal rigs etc. into the rod tip and stops your rig at a consistent depth
for convenient checking and changing of baits and sinkers.
- Line stretch can cause an inaccurate reading at the surface. Simply reset the counter to zero at the surface.
3.
After adjusting length, press the
INVERSE COUNTER
BUTTON
for 2 seconds.
When blinks, this procedure is completed.
Default setting is 2.0 m. (Without pressing the
RESET
BUTTON
the winding stops at a depth of 5.0 m.
The lamp will blink when the setup has been completed.
4.
When checking or changing a bait, simply wait until the reel
automatically stops winding and raise the rod tip.
Use
Checking and changing sinkers, baits etc.
Functional setting operation
(3. Auto stop function)
2.
Raise the rod and adjust the line length from the rod tip so you
can reach the rig easily. In the figure, its length is 1.5 m.
3
2
1.5m