Functional setting operation, Before you begin fishing.), Attention – Daiwa SEABORG-300FB User Manual
Page 21
19
Surface depth setting
When the main line is cut or broken off.....
Before you begin fishing, make sure the counter is set to zero at the waterʼs surface.
This is extremely important to ensure accurate fishing depth readings.
3.
Lower the terminal rig to the waterʼs surface and press the
RESET BUTTON
. (water surface zero setting)
The display resets to
0.0
and lights up.
2
1.
Connect the reel to the battery, put the line through all the
guides, and prepare your terminal rig.
2.
Place the rod into the rod holder in the position it will normally
rest while fishing.
- Should your line break, revise data as follows.
- Wind the line to the rod tip, and press the
RESET BUTTON
for 2
seconds. If the display shows
0.0
then your re-adjustment is
complete and data has been revised.
- Do not continuously hold down the reset button. This will
prevent any counter errors.
Functional setting operation
(2. Before you begin fishing.)
3
Attention
When new line is wound up, or when line has been pulled under heavy tension, line stretch
may cause a gap in the depth reading at the surface. Simply reset the surface setting with
the reset button.