Line data input, Inputting the drawer), P3 inputting the drawer – Daiwa SEABORG-300FB User Manual
Page 18: Attention
Advertising
16
Line data input
(Inputting the drawer)
5
7
5.
Press the
RESET BUTTON
for 2 seconds.
This will show the digits
100
in the lower area of the counter.
6.
Pull an additional 50m of line from the spool.
7.
Press the
RESET BUTTON
for 2 seconds to show
100.0
on
the upper counter.
8.
Wind up the 100m of line you pulled from the reel. This
completes the procedure.
P3 Inputting the drawer
If “
Err
” appears in the display, go back to STEP 2 and re-enter
the data again.
Attention
1.
Do not wind the end of the line onto the spool because it causes incorrect length calculation.
Move the power lever to OFF, and wind manually when nearing the end of the line.
2.Braided lines less than 10 lb. test can not be inputed.
Advertising