Dynon Avionics EFIS-D100 Pilots Users Guide - Manual (Page 41)

EFIS Operation
5-8 EFIS-D100 Pilot’s User Guide
In a DSAB network, you can only set the Zulu time on the DSAB master, and only if it is not synchronized to
GPS time. You can set the local time on all units individually.
To change the local clock when moving through time zones or to enter daylight saving time, simply change only the
hours (and, if necessary for the time zone, the half-hour offset) for the local time. Be aware that connecting to the EFIS-
D100 with the Dynon Product Support Program resets the time; do not set the time until you have performed all of the
PC interface operations. Refer to the following set of tips as you set the clock:
 Set both the local and Zulu times in military time. You have may display the time in either military or standard
12-hour format, as described below.
 SEL► moves the highlight to the next set of digits. The order of selection is 1. Local hours, 2. Local minutes
(adjustable only as ½-hour offsets from Zulu minutes), 3. Zulu hours, 4. Zulu minutes. When connected to a
GPS, you are not permitted to adjust the Zulu time on the EFIS-D100
 DEC- and INC+ change the selected set of digits. To speed up the process, press and hold the desired button. If
you pass the desired value, you may simply back down to it by pressing the button corresponding to the
opposite direction.
 Incrementing or decrementing the minutes digits resets the second count.
 In the CLOCK > FORMAT menu, press LC/ZU to change between local and Zulu time display on the EFIS
page. Press 12/24 to change between standard and military time display on the EFIS page
SHOW/HIDE DISPLAY ITEMS
In the EFIS > SETUP > CLUTTR menu, you can turn on or off almost every item displayed on the EFIS page. As with
all other menu items, these options are abbreviated to commands containing 6 letters or fewer. Pressing a button