Dynon Avionics EFIS-D100 Pilots Users Guide - Manual (Page 44)

EFIS Operation
EFIS-D100 Pilot’s User Guide 5-11
Abbreviation Display Item Function
CRS Course Pointer Toggles the display of a “V”-shaped course pointer on the heading tape. Li
CDI, this can only be displayed when the EFIS-D100 is receiving a valid co
from the NAV source selected on the HSI page. If the CRS button status di
“Y” and no course pointer is displayed on the he ke the
urse
splays
ading tape, the EFIS-D100 cannot
detect your NAV radio or GPS, there is no active course set, or there is no
NAVSRC chosen.
TRIM Elevator Trim Displays the elevator
is properly connected
EMS setup. trim. This can only be displayed when an elevator trim sensor
to a DSAB-connected EMS device, and configured in the
CHECK FIRMWARE VERSION
The EFIS > SETUP > VRSION menu gives you two important p
firmware version; and the number of hours the E ieces of information: your EFIS-D100’s current
FIS-D100 has been on. If you require technical support or other
assi Dynon, please have your firmware version ready when you call or write. stance from
INFO – Informational Items
In the EFIS > INFO menu, you have the option of displaying an
informational display item on either the left or right side, or
both. You may display a voltmeter (VMETER), g-meter
(GMETER), vertical speed indicator (VSI), OAT/true airspeed/
density altitude (OAT), and engine RPM/MAP info (ENGINE). More detail about each of these is given below.
Voltmeter