Leica Geosystems TPS1100 Professional Series - User Manual - Manual (Page 35)

35
TPS1100 - User Manual 2.2.1en Checking and adjusting
6
10
12
21
If the differences between the hori-
zontal and vertical angles do not
exceed ±27' ( ±0.5 gon ), the display
shows that the instrument is ready to
measure. The user is made aware by
an acoustic signal that the
key is
redefined as 'OK'.
V-index error , continued
Confirms the readiness to
measure and changes the
display.
Sight the target accurately again.
Starts the second
measurement.
After the measurements are complete,
the older and newly-determined V-
index errors are displayed.
Stores the new values.
Repeats the complete V-
index error determination
procedure.
Leaves the old values
unchanged.
If the value of the V-index
error (i) exceeds 54' (1 gon)
you should repeat the measurement
procedure. If this value is exceeded
repeatedly, please contact service.
Main\ V-Index Error
old new
i Vind: 0°00'03" -0°00'22"
Accept new value(s)?
YES RETRY NO
MC
QUIT
Telescope Positioning
Hz- and V-positioning:
Set direction(s) to zero.
∆ ∆ ∆ ∆ ∆ Hz : 0°00'00"
∆ ∆ ∆ ∆ ∆ V : 0°00'00"
OK ABORT
MC
QUIT
Main\ V-Index Error
Aim accurately at the same
target in other face
Hz : 163°18'54"
V : 266°12'19"
MEAS
MC
QUIT