Leica Geosystems TPS1100 Professional Series - User Manual - Manual (Page 73)

73
TPS1100 - User Manual 2.2.1en System functions
6
10
12
21
26
Reduced distance corrections ppm
For standard applications the
distance is corrected only on account
of atmospheric influences.
The geometrical correction and the
projection distortions are set to
"0.00". Heights are reduced with the
standard refraction coefficient
Activate the function "PPM
Atmospheric" from the dialog
"Function Selection".
Input of air pressure and temperature
or
Input of ppm value.
The values for pressure and
temperature are erased.
\ PPM Corrections
Enter your correction values
Atm.pressure : 1013.3 mbar
Temperature : 12.0 °C
ppm total : -0.0
CONT
MC
QUIT
Refraction correction
The refraction correction is taken into
account during the calculation of the
height difference.
Sets the refraction coefficient
to standard values.
Distance corrections ppm, continued
\ REFRACTION CORR.
Set coeff. of refraction
Correction : ON
Refr.coeff. (k) : 0.13
CONT DEFLT
MC
QUIT
Measurement & recording (REC)
MEAS\ Measurement & Record
Point Id : 1
Attrib. 1 : -----
Refl. Ht. : 1.500 m
Hz :286°55'50"
V : 91°16'20"
Horiz.Dist. : ----- m
ALL DIST REC SetHz >DISP
MC
INPUT Del B I<>II INDIV QUIT
Elev.Diff. : ----- m
East : ----- m
North : ----- m
Elev. : ----- m
The data shown above represent the
standard display mask.
Measurement block
recording. The recorded
measurement-block corresponds to
the active recording template. The
last measured distance is also
recorded.