Panasonic TC-LT1 Series - Manual (Page 15)

Setting Up
■Placement on a table.
Remove the mirror unit and the setting stand (see page 8) Preparation:
Unless the projector is placed flat, you will not be able to see clear images without distortion.
If you are placing the projector on a table, please make the following adjustments to make sure that the stand is not off
balance.
Adjustments
o
Lift the front of the projector until it is flat. While
holding the projector in this position, press the two
adjuster buttons at the bottom of the projector.
The setting legs (left and right) will extend until they
come into contact with the setting surface.
• Please do not let go of the projector until both
of the setting tegs on the left and right of the
projector come into contact with the setting
surface.
Adjuster button
Until 33mm
Adjustable leg
@
Letting go of the projector.
When you let go of the adjuster buttons, the adjusting function will be locked.
To Retract the Setting Legs.
Lift the projector slightly up and press on the adjuster buttons. While pressing these buttons, gently let the
projector down.
Please do not press the adjuster buttons unless you are supporting the projector with your hands.
Releasing the lock and letting the projector fall abruptly onto the stand may break the projector.
Setting the projection method.... Please see page 13.
PICTURE SETTING 1
SIGNAL MODE 2
POSITION 3
SETTING
CLOCK
FEATURES
LANGUAGE
4
Select “SETTING V
15