Replacing the lamp unit, Caution – Panasonic TC-LT1 Series User Manual
Page 31
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Replacing the Lamp Unit
A
Caution
Make sure that the lamp is fully cooled
before replacing the lamp unit.
o
After using the projector the lamp will be very hot.
Touching it can cause burns, and objects placed in
contact with the lamp may be deformed or damaged
by the heat.
■ When to Replace the Lamp
The lamp monitor will shine red when the Lamp Unit has been
used for 7000 hours.
Please replace the lamp when the lamp monitor turns on, since
the lamp will become darker or burn out with the expiration of
time.
‘The expected life is 7000 hours. Depending on the conditions of
use, the lamp may need to be changed before this time elapses.
Lamp Monitor Display
Please Observe the Following When Changing the Lamp
• The optical lamp is a glass product. It may shatter if struck by hard objects or if dropped. Please be careful when handling the
lamp.
• The old lamp unit removed may shatter if handled roughly.
• A “+” screwdriver must be used when replacing the lamp unit. Please be careful that your hand does not slip when using the
screwdriver,
• Follow the instructions on the following page when replacing the lamp unit, and please turn off the Lamp Monitor Display.
•
• Lamp Units are sold separately. Please inquire with the dealer from whom you purchased the Projector.
Lamp Unit Spare Part No ; TX2VL010N05
31