Panasonic PV-4614 - Manual (Page 26)

VCR Plus+ Programming
Before you begin, make sure...
□ The clock is set.
□ VCR Plus+ Set Up is complete (See pages 24, 25).
c ip j 1 1 ] CS)
O GD f
Multi Function
Display
HCXTV
o o o
CASKP
Is w
050 0
SPEED
CLEAR
Use normal Timer Recording steps if:
• the PlusCode for a program is not listed.
• you anticipate the program, such as a sporting
event, to run over the scheduled stop time.
See page 21 to:
• Cancel a timer recording in progress
• Replace program contents
• Review or Clear program contents once set
Important notes when using a DSS receiver
• When recording programs via a DSS receiver, the
DSS receiver must be left on.
• When recording programs via an antenna or cable,
the DSS receiver must be turned off.
VCR Plus+ and PlusCode are trademarks of
Gemstar Development Corporation.
The VCR Plus+ system is manufactured under
license from Gemstar Development Corporation.
@ l! VCRPÌUS+
o
Push VCR
Plus+ to display
the VCR Plus+
screen.
VCR PIUS+
ENTER,VCR PLUSCODE
TO END PUSH VCR Plus+
Push the Numbered
Keys to enter the
PlusCode number.
Refer to your local TV listings.
VCR PIUS+
ENTER VCR PLUSCODE
123456
TO CORRECT PUSH CLEAR
TO ENTER PUSH VCR Plus+
To make corrections
Push the CLEAR button repeatedly to delete the PlusCode
number. Then, enter the correct number.
d);
VCR Plus+
I o
Push VCR Plus+ to
lock in your program.
Push 1,2 or 3 Key to
select the program type.
VCR PIUS+
1 ONETIME
2 DAILY (MON-FRI)
3 WEEKLY
TO SELECT PUSH 1,2 OR 3
TO END PUSH VCR Plust
To change the recording speed:
Press the SPEED button for SP, LP or SLP.
To cancel program contents:
Press the CLEAR button.
DATE START STOP CH
TO CHANGE RECORD SPEED
PUSH SPEED KEY
TO CANCEL PUSH CLEAR
TO END PUSH VCR PIUS+
If you use “A" connection on page 24, the channel shown in
the on-screen display in this step will always be the cable
box output channel number.
VCR PIUS+
o
1 Push VCR Plus-H
■ to complete the
j program.
If you're using a Cable Box, make
sure that it is tuned to the desired
channel and the power is left on for
timer recording.
TURN VCR OFF
FOR TIMER RECORDING
AND
LEAVE CABLE BOX POWER ON
This display may differ
depending on your
cable box hook-up.
Push VCR
POWER off to
set the timer.
-BIS13-
Multi Function Display
For a list of publica^ons that carry the PlusCode numbers in your area, call 1 - 800 - 258 - 4827.
You can obtain unlisted PlusCode numbers by calling 1 - 900 - 454 - 7587. Call costs approximately $.95 per minute.
VCR PlusCodes can not be used to program the VCR to record DSS channels.
Avoid overlapping program times.
An on-screen display will indicate if an invalid PlusCode number has been entered.
An on-screen display will indicate when all timer programs are full.
26