Panasonic Convertible Camera AW-E800 - Manual (Page 42)

® Electronic Shutter Mode Setting [Shutter Mode:
Step/ELC/S/Scan]
Step:
Electronic shutter operates at the speed
selected by the Electronic Shutter Step Setting
ELC: Electronic shutter is controlled to automatical­
ly adjust the luminance.
S/Scan (Synchro Scan):
Electronic shutter oper­
ates at the speed selected in Electronic Shutter
Synchro-Scan Setting ©.
- Note------------------------------------------------------------------------
If Frame 1 is selected in CCD Read Out Mode
Setting ©, Electronic Shutter Mode Setting cannot
be added.
Electronic Shutter Step Setting
[Step: OFF/1/100 -1/10 000]
This setting is possible only when Step is selected
in Electronic Shutter Mode Setting
OFF:
Electronic shutter is turned off.
1/100,1/250,1/500,1/1 000,1/2 000,1/4 000,
1/10000: Electronic shutter operates at one of
these speeds as selected.
- Notes-----------------------------------------------------------------------
• In case of using the RCU (RGB), none of the shut­
ter speeds-1/250, 1/2 000, 1/4 000, and 1/10 000
can be selected.
• In case of using the hybrid control panel, only
OFF, 1/100, or ELC can be selected.
• If the lens iris switch is at M (Manual) when oper­
ating the camera alone or when the iris switch on
the RCU (RGB) is at AUTO, ELC may not function.
Set the lens iris switch to A (Auto).
• Flickering may increase at ELC under fluorescent
lights.
Ф Electronic Shutter Synchro Scan Setting
[Synchro Scan: 60.58Hz - 15.75kHz]
This setting is possible only when Electronic Shutter
Mode Setting ® is at S/Scan,
Bar noise can be reduced by synchro-scan adjust­
ment in shooting workstation scenes, for example.
* For luminance setting at each shutter speed and
synchro-scan shutter speed, refer to the table on the
next page.
-
40
-