Panasonic NV-SD400 - Manual (Page 11)

Setting the Remote Controller
for Operation of your TV
Tuning the TV to your VTR
Setting the Remote Controller
for Operation of your TV
You can operate some manufacturer of TVs (see following
table) using the supplied Remote Controller after this
Preparation
Install the batteries in the remote controller. See page 7.
Operations
1 Turn on the TV.
Press corresponding operation button
to your TV manufacturer (see following
table) while keeping TV SELECT
pressed.
• If setting is correct, TV will be turned off
automatically.
TV Manufacturer Operation Button
Panasonic/National
TV SELECT DISPLAY
o
•
0
TVSELECT ppioG
o
*
®
TVSEl^CT CANCEL
O
*
Q
TV^ECT TIMER REC
O
*
L®J
SONY
TV SELECT
O
TOSHIBA
TV SELECT
O *CID
JVC
TV SELECT
o
HITACHI
TV SELECT
O "CID
MITSUBISHI
TV SELECT
O " CO
TV SELECT
O
"
CO
SHARP
TV SELECT
0 "CO
PHILIPS
TV SELECT
O *<3:>
NEC
TVSELECT
O
SANYO
TV SELECT
O
When the TV manufacturer Is Panasonic/National or
MITSUBISHI:
When the TV’s power is turned off in step 2 above, turn it
back on and adjust the TV's volume using this remote
controller. The volume can be adjusted if the operation
button matches the manufacturer of TV.
If it is not possible to adjust the TV’s volume, try pressing
the other operation button to match the manufacturer of TV
again until the volume can be adjusted.
Note:
Some TV models cannot be operated using this remote
controller.
§
.C
CD
CO
(11)