Panasonic NV-F70EA - Manual (Page 44)

DUBBING (COPYING) (CONT O)
Connecting to a VHSA^HS-C Movie Equipped with
Synchro Edit Function
It is possible to synchronize the playback start and stop of
the VHSA/HS-C Movie with the recording start and stop of
this VTR.
Preparation
• Make the necessary connections as shown in the con­
nection diagram.
• Set the Edit Switch (Noise Filter/Edit Selector) on both the
VHSA/HS-C Movie and on this VTR to “ON” (or “EDIT
ON").
Q Put the VTR in the recording pause mode.
^ Put the VHS/VHS-C Movie in the still playback mode.
• Put the Movie at the point where you want to start
editing into the still playback mode.
^ Press the Pause/Still Button on the VTR.
•The VHSA/HS-C Movie changes over to the playback
mode and the dubbing will start automatically.
To Leave Out Unwanted Scenes
(T) Press the Pause/Still Button on the VTR.
•The VTR changes over to the recording pause mode
and the VHS/VHS-C Movie changes over to the still
playback mode.
( 2 ) Operate the VHS/VHS-C Movie to skip the unwanted
scenes and then put it in the still playback mode again.
@ Press the Pause/Still Button on the VTR.
•The dubbing will restart.
To stop the dubbing, press the Stop Button on the VTR and
then put the VHS/VHS-C Movie in the stop mode.
When an NV-F70 is used as both recording and playback
VTR, the connection shown above makes possible dubbing
of index signals, too.
The operation is the same as for ordinary dubbing.
44