Before requesting service – Panasonic NV-F70EA User Manual
Page 47
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
1
BEFORE REQUESTING SERVICE
Before requesting service, check the foliowing points once
again.
SYMPTOM
CAUSE
REMEDY
Power doesn’t turn on.
Mains lead is not connected.
Connect mains iead to mains outiet.
The Timer Record Function is set to “On”.
Set the Timer Record Function to “Off”.
Power is on but unit doesn’t
operate.
Dew condensation inside the VTR.
Wait until the Dew Indicator “
d
’’goes off.
Safety devices are operating.
Turn off the VTR On/Off Switch, disconnect
mains cord from outlet, then reconnect mains
cord to mains outlet and turn on the VTR
On/Off Switch again.
TV programmes cannot be
recorded.
Connection of aerial lead is not correct.
Connect aerial lead correctly.
Reception channel is not properly tuned.
Tune reception channel.
The Input Signal Selector is not set correctly.Set the Input Signal Selector to “Tuner”.
OTR Function (One-Touch Timer
Recording) cannot be performed.
Clock is flashing "0:00”.
Set clock to present time.
Unattended timer recording
cannot be performed.
Recording start or recording stop time setting
is incorrect.
Set recording start and recording stop time
correctly.
The Timer Record Function is set to “Off”.
Set the Timer Record Function to “On”.
Clock shows incorrect time.
Adjust ciock to present time.
Clock is flashing at “0:00”.
Set clock time and perform timer setting.
The Input Signal Selector is not set to
“Tuner”.
Set the Input Signal Selector to “Tuner”.
If you attempt to carry out
Recording, Timer Recording,
or OTR, the cassette will be
automatically ejected.
Accidental erasure prevention tab on the
cassette is broken out.
Cover tab hole with adhesive tape.
Recording via external input
terminals cannot be performed.
The Input Signal Selector is not set correctly.
Set the Input Signal Seiector to “Line/Audio”.
Recorded programmes with
two-channel sound (stereo,
bilingual or Simulcast) can not be
played back.
Setting of the Audio Output Mode Selector
Button on the Remote Controller is not
correct.
Press the Audio Output Mode Selector Button
on the Remote Controller to select the desired
audio playback mode. (See page 28.)
Hi-Fi tracking is misaligned.
Precisely align the tracking of the hi-fi sound
track.
47