Panasonic NV-F70EA - Manual (Page 45)

INSERT EDITING
When this type of editing is done, the picture and the sound
are recorded on the tape as shown below. However, if no
new sound is input, the original sound remains only on the
“normal” audio track of the tape because the original Hi-Fi
sound will always be erased during insert editing.
Video and Audio Track Recording Pattern
1
Preparation
• Insert a video cassette with the erasure prevention tab
intact.
•When performing insert editing from another VTR, set the
Noise RIter/Edit Selector to “EDIT ON”.
• Set the Input Signal Selector according to the type of in­
sert editing to be performed.
"LINE/AUDiO”: When inserting picture and sound from
equipment connected to the Video Input
Socket and the Audio Input Sockets on
the rear of this VTR.
“TUNER”: When inserting scenes from a TV pro­
gramme.
0 Press the Jog/Shuttle Button.
^ Use the Shuttle Ring and the Jog Dial to search for the
point where you want the editing to end (end point),
and put the VTR into the still playback mode.
0
Press the Reset Button on the Remote Controller to
reset the Tape Counter to “0:00.00”.
0 Use the Shuttle Ring and the Jog Dial to search for the
point where you want the editing to start (start point),
and put the VTR into the still playback mode.
0 Press the Insert Editing Button.
(The Insert Editing Indicator lights up.)
0 After the picture to be inserted is prepared, press the
Pause/Still Button (I I).
(The insert editing will start.)
0 Press the Stop Button as soon as the Tape Counter
shows “ 0 : 00 . 00 ”.
------------------- --------------------------------------------------------------------------V.
• It is not necessary to operate the Tape Speed Se­
lector.
•The picture quality of an inserted part is always
somewhat inferior to that of the original.
•Avoid performing insert editing repeatedly on the
same part of the tape because the picture quality of
that part becomes inferior.
•The inserted picture may contain slight colour noise
or the colours may be unstable.
Playback of a Tape on Which Insert Editing Was
Performed
The sound inserted during insert editing is recorded on the
Hi-Fi sound tracks (STEREO, LEFT, RIGHT). If the normal
sound track is selected, the original sound before the insert
editing will be heard. Select the desired sound with the
Audio Output Mode Selector on the Remote Controller.
Hi-FI/Normal Mix Switch
Set this switch to “On”, if you want both the “Hi-Fi” sound
and the “normal” sound to be played back mixed together.
•The mixed sound may not be very clear.
Always set this switch to “Off”, except when playing back
a tape on which the insert editing or audio dubbing was
performed.
4 5