Panasonic PT-AE1000 - Manual (Page 12)

Remote control operation
® C3D EOO
E 3 G 3 Q
You can operate the projector with the Remote control
within the remote range 7 m.
# Facing to the projector
Ensure the Remote control emitter is facing to
the Remote control signal receptor on front of
the projector and press the required buttons to
operate.
% Facing to the screen
Ensure the Remote control emitter is facing to
the screen and press the required buttons to
operate the projector. The signal will be reflected
off the screen. The operating range may differ due
to the screen material.
NOTE:
• The Remote control may malfunction under
strong light such as a fluorescent. Do not let
strong light shine onto the signal receptor,
• If there are any obstacles in between the remote
control unit and the receptor, the Remote control
may not operate correctly.
You can switch the input method manually
by pressing the INPUT button. Press the
button several times or press ◄ ► to cycle
through the input methods as follows. The
actual projected image will be changed in a
while.
COMPONENT IN
PC IN
♦ HDMI2 IN
SCART IN
HDMI1 IN
S-VIDEO IN
VIDEO IN
Graphical guidance will be displayed on the upper right
of the display and you can confirm the selected input
method which is hilighted in yellow. See "INPUT
GUIDE" on page 38.
Remote control operation
COMPONENT IN
SCART IN
S-VIDEO IN
VIDEO IN
HDMI1 IN
HDMI2 IN
PC IN
Connected to COMPONENT
IN terminal equipment’s
signal
Connected to SCART IN
terminal equipment’s signal
Connected to S-VIDEO IN
terminal equipment’s signal
Connected to VIDEO IN
terminal equipment’s signal
Connected to HDMI terminals
equipment’s signal
Connected to PC IN terminal
equipment’s signal
NOTE:
• If you select an unplugged input method, the
guidance will blink on and off several times.
• See "List of compatible signals" on page 45,
• See "Connections" on page 18.
In a dark room, you can turn on the button
backlight to operate the Remote control.
Press the button on the upper right corner of
the unit to turn on the backlight and enter
the light-on mode.
^ When projecting an image, press FREEZE
IfREEZEj to capture the projected image and display
it on the screen as a still picture. Press
again to escape.
After 30 seconds without any operation, the backlight
will go out. Press any but the LIGHT button to turn on
again. To escape from the light-on mode, press the
LIGHT button.
NOTE:
• Some menu items are not available to reset by
pressing the DEFAULT button. Adjust each menu
items manually.
NOTE:
• Escaping from the freeze mode is available by
pressing any button except the LIGHT button.
| aspect |
The aspect ratio is selected automatically,
or you can switch it manually by pressing
the ASPECT button. Press the button
several times to cycle through the different
aspect type as follows. See "ASPECT' on
page 35.
VIDEO/
S-VIDEO/
COMPONEN
T (YP b P r )
PC (RGB)
HDMI
4:3 :ZÖÖM2'
16:9
14:9
ZOOMI
JUST.
4:3 16:9
4:3 16:9
NOTE:
• If you project an image with an unmatched aspect
ratio, the image may distort or some portions may
be cropped. Select an aspect ratio which
preserves the intention of the image creator.
• The order of ASPECT types is defined not only by
the input method but also by the input signals.
See "List of compatible signals" on page 45.
• If you project a copyrighted image enlarged or
distorted by using ASPECT function in
commercial use in a public place, such as a
restaurant or hotel, you might infringe on the
copyright of the creator which is protected by
copyright law.
22 - E nglish
E nglish - 23