Panasonic RX-DT770 - Manual (Page 13)

To cancel program play;
Press «/CLEAR in the stop mode.
“CLEAR” appears on the display and all the programmed contents
will be cleared.
When “CD FULL” appears:
This indicates that an attempt has been made to program more
than 24 tracks. No more than 24 tracks can be programmed.
Memory retention of programmed tracks
This programming of the tracks will be retained in the memory even
if play is stopped at any time or the unit is turned off.
“P” appears on the display indicating that programmed memory
remains and the following operations are available.
Indicates programmed memory remains
To check what has been programmed:
While “P” is on the display, press or in the stop mode.
Each time these buttons are pressed, a track number and its play
sequence can be checked.
To add an entry;
While “P” is on the display, follow these steps.
1. Press one of the disc buttons (DISC 1-3)
2. Press or to select the track to be added.
3. Press MEMORY,
To clear a programmed track one by one:
(Available only from the remote control)
While “P” is on the display, follow these steps.
1. Press or repeatedly until the display shows the disc and
the track number you want to cancel.
3 r Tí
_) (_ M
(P^H)
t ___ n
u J
2. Press CANCEL during desired disc and track number is on the
display.
To clear ail tracks:
Press «/CLEAR once in the stop mode or twice in the play mode.
The programmed memory will be cancelled in the following
cases;
• When
± CD EJECT on the front panel is pressed.
• When you disconnect the power cord without installing the memory
back-up batteries.
REPEAT
o
Random play
(Available only from the remote control).
This unit will randomly choose a track from the disc in the CD
PLAYER.
To play 2 or more discs randomly:
Press CONTINUE and RANDOM.
The unit will stop automatically when all
the tracks on all the loaded discs have
been played.
To clear random play:
Press «/CLEAR to turn off the I RANDOM I indicator.
• Skipping is not possible to track which have been played (see
page 11).
• Search (see page 11) is possible only within the track in play.
To repeat tracks
(Available only from the remote control)
All the tracks or the programmed tracks are played repeatedly.
REPEAT
%
In the play or stop mode,
press REPEAT.
Lights
To release repeat play:
Press REPEAT.
To listen to the same track over and over again:
Program the track to be repeated (see page 12) and press REPEAT.
To play 2 or more discs repeatedly:
Press CONTINUE and REPEAT.
13