Panasonic RX-DT770 - Manual (Page 9)

listening to Tapes
Only norma! tapes (TYPE I) can be used with this unit. This unit has a dual cassette system, which means that a tape can be played back with
both Deck 1 and Deck 2. This page shows an example using deck 1.
TAPE
■/A
STOP/EJECT
>
PUY
To stop play:
Press TAPE.
<J)c^ T HPb
3 1 . _ _ _ _ _ _ _ _ _
Press STOP/EJECT, load the
tape and close the cassette
lid.
Load the tape with the side on which
playback is to commence facing you.
Reverse side
Top side
Press PLAY to start play.
Type of tape which can be played on this unit:
Normal position/TYPE I О
High position/TYPE II X
Metat position/TYPE IV X
This unit will not be able to do full justice to characteristics of high-
position tapes and metal position tapes even if they are played
back.
To rewind or fast forward the tape
In the stop mode, press REW/
REV or FF/CUE.
Do not press PLAY during rewinding or fast fonwarding, as this may
jam the tape. Be sure to press STOP/EJECT before proceeding to
the next operation.
To search a particular spot on a tape
\ During playback, press REW/
/CUE I pgy FF/CUE,
Tape play is resumed when the button
is released.
Press STOP/EJECT.
To temporarily stop play:
Press PAUSE.
To resume play:
Press PAUSE again.
Automatic playback relay
(Deck 2 to Deck 1 )
When Deck 2 playback has finished. Deck 1 playback starts auto­
matically.
1 Insert the playback tapes into Deck 1 and Deck 2.
2 Press Deck 2 PLAY.
3 Press Deck 1 PAUSE, then press PLAY.
Full autostop
During playback, recording, fast fonvard or rewind when the tape
reaches its end, the automatic stop system wilt release the opera­
tion buttons.