Speaker system connection, Attaching the speakers, Detaching the speakers – Panasonic RX-DT770 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Speaker System Connection
This unit can be used as a one-piece portabie stereo CD system, or
a three-piece component system, by attaching or detaching the
speaker system.
Before attaching or detaching the speakers, be sure to disconnect
the speaker cabies from the speaker terminals. Be sure to press
POWER to turn off the unit before connecting/disconnecting the
speaker cabies.
Attaching the speakers
1. Align the speaker with the main unit as shown
in the figure, interlock the grooves and press
down.
2
. Connect the colored speaker cable to the same
colored speaker terminals.
Detaching the speakers
1
. Unlock the speaker release levers by pulling
them in the direction shown beiow, and slide
each speaker up.
2. Connect the speaker cables to the speaker
terminals.
3. When using the unit with the speakers attached,
wind the speaker cables as shown above.
Since a strong magnet is used for the speaker, keep magnetized
commuter passes, tickets or personal credit cards, recorded tapes,
watches, etc. away from the set. The speaker magnet in the set
may damage them.
Caution
Use the speaker(s) only with the recommended system.
Failure to do so may lead to damage to the amplifier and/
or the speaker, and may result In the risk of fire.
Consult a qualified service person if damage has oc
curred or if you experience a sudden change In perfor
mance.